700-2700MHz Radome 3dBi 4G LTE Omni-Directional Antenna – Clearance



4G LTE Omni-Directional indoor off-white color radome antenna

    This 700-2700MHz Radome 3dBi 4G LTE Omni-Directional is an indoor antenna that is the ideal choice for wall, ceiling and other surface installations.

    It is compatible with the majority of cellular carriers in the United States.

    The antenna is equipped with a N type female connector.   It's off-white color radome blends easily into most building aesthetics.  We recommend sealing the antenna connectors with dielectric grease and self-bonding silicon tape, when installing any outdoor antenna and cabling.
    One of our customers shared his project of shelf mounting the antennas for MIMO reception.
    700-2700MHz Radome 3dBi 4G LTE Omni-Directional Antenna
    Ceiling Mount Example for 2×2 MIMO setup. NEXQ6GO used in this example.
    See the tabs above for the “Ceiling Mount Install Instructions”
    Frequency Range 700-2700MHz
    Polarity Horizontal
    Pattern Omni-directional
    Horizontal Beamwidth 360 degrees
    Gain 2.5dBi, 3dBi
    Connector Type N Type Female
    Mounting Hardware Universal Wall & Ceiling Mount
    Weight 14.1 oz
    Dimensions 6.5 × 6.5 × 6 in
    Antenna Type

    4G LTE Indoor Omni-Directional

    Antenna Cable Connector 1

    N Type Female Straight


    AT&T, Boost Mobile (Sprint), Cricket Wireless (AT&T), FreedomPoP (Sprint), MetroPCS (T-Mobile), Mint (T-Mobile), Project Fi (Sprint, T-Mobile), Simple Mobile (T-Mobile), Sprint, T-Mobile, U.S. Cellular, Verizon, Virgin Mobile (Sprint)

    Specification | Brochure

    Ceiling Mount Install Instructions

    2 reviews for 700-2700MHz Radome 3dBi 4G LTE Omni-Directional Antenna – Clearance

    1. mike dailey

      Based on the other review, I decided to try two of these on top of my RV. Worked well for a few weeks, then the signals got really bad. When I replaced them with a set of onmi antennas, I discovered these were full of water. When using outdoors, I recommend installing them with the pointed end aimed up. Otherwise, when the tip is installed point down, use silicon around the top of the antenna and drill a small hole in the bottom. I started to do this when I installed them but the directions did not mention the need to do so.

    2. usaShane

      good little antennas for indoor use. mounted mine under a small shelf to hang high on the wall. router is located on same shelf. big improvement on signals. would probably work outside.

    Add a review

    This site uses Akismet to reduce spam. Learn how your comment data is processed.

    In stock

    Warranty: 30 Days